Why do you have to wear a seat belt while driving ?

A seat belt in a car is a system used to secure passengers in their seats while traveling and increase their safety in the event of an accident. 

Seat belts usually consist of a belt or lap belt that wraps around the upper part of the passenger's body and is secured by a lock on the lower part of the seat.

Seat belts are one of the most important basic safety systems for car drivers and passengers, as they significantly reduce the risk of injury in the event of an accident.

 Traffic regulations in many countries require that all occupants of the vehicle wear seat belts, whether in the front or rear.

Types of car seat belts

. to examine

Periodically check the condition of the belt as follows:

Pull each strap out completely and check for dents, cuts, and scrapes.

Check whether the hook works normally and whether the seat belt is effectively tightened.

If the belt does not retract effectively, cleaning the belt may solve the problem.

Just use a mild detergent and warm water.

Try not to use bleaching or cleaning solvents.

Make sure the tape is completely dry before removing it.

Any seat belt in poor condition or not working properly will not provide proper safety and should be replaced as soon as time permits.

Seat belts worn in the event of a collision may not provide a similar level of safety in the resulting accident.

warning

Failure to check or follow up could result in real harm or death if it does not work properly as intended.

Check seat belts frequently and correct any problems as soon as time allows.

Customer shall not make any modifications or additions that will cause the belt replacement unit to fail to remove slack, or cause the belt harness to fail to remove slack.

・ Even if the damage to the tip is not obvious, the entire tip must be replaced after severe wear.

You should take care to keep a strategic distance from staining the tape with glossing agents, oils, and synthetic compounds (particularly sulfuric acid). Cleaning is safe with mild detergents and water. If the belt ends up worn, dirty, or damaged, the belt must be replaced

seat belt

The absolute best safety equipment because it keeps you connected to the vehicle so you can take advantage of the many potential health benefits.

It also helps protect you from being tossed into or out of the vehicle by other passengers.

When worn properly, they also keep your body in place in the event of an accident so you can take advantage of the additional insurance airbags they provide.

In addition, it helps ensure that many accidents are avoided, including:

• Positive effect
• side effect
• end of the road
• rotation
• warning

Even though your car has airbags, wearing them improperly increases the chances of serious damage or death in a collision.

Make no mistake, you and your passengers are wearing seat belts and wearing them legally.

knee / bears

Each of the five seats is equipped with a knee/bear seat with crisis-locking extenders.

During typical driving, the retractor gives you the opportunity to move without restriction while remaining within seat belt pressure.

In the event of a crash or sudden stop, the retractor locks in to keep your body in check.

Models with lockable retractor

The belt also has a lockable retractor to work with the self-tapping frame.

Introduction of child restraint systems with lap/shoulder belts

Follow these rules to make use of it properly:

All passengers are expected to sit upright with their backs in their seats and remain so throughout the flight. Reclining and reclining can reduce the fit of seat belts and increase the potential for real harm in the event of an accident.

Never bring your knees/shoulders under your arms and never face your sincerity. This could cause serious injuries in an accident.

No two people should use the same things. If they do, they may actually get injured in a car accident.

Don't put anything superfluous. Devices designed to enhance comfort or reposition parts of the seat belt over the shoulders can reduce defenses and increase the chances of real damage in a crash.

He remembers

Your vehicle scans the driver and front passenger*

If the release shift is turned to ON II * 1 before the driver's seat belt is attached, a beep * will sound and the symbol will flash.

If the driver is not wearing a seat belt before the buzzer stops, the indicator will remain on.

While driving, the buzzer will be static intermittently and the indicator will flash for the driver and front passenger*.

Programmable seat belt pretensioners*

The front seats have programmable seat belt pretensioners for added safety.

In severe to head-on frontal collisions, the pretensioners stabilize the front seat belts normally, and in some cases, regardless of sufficient impact